I’ve seen this craft all over Pinterest, with a couple of variations, but essentially it’s all the same technique – cans, paint and fabric create your choice of a themed windsock.
Like most of my crafts, it was easy, fun, and then suddenly took a little weird turn but it ended up just fine.
To start, I saved two aluminum cans from cooking during the week. Many of the craft posts suggest using coffee cans, but the coffee we buy comes in a bag, so that wasn’t a choice.
I painted one can white, and the other green. Fun fact: Fabric paint isn’t just for fabric. My only tube of green paint was part of a fabric paint set, but I figured it wouldn’t hurt to try it on a can. If it didn’t stick, I could just toss it in the recycle bin and start over.
While I waited for the paint to dry, I browsed the internet and my Pinterest board full of doodles and practiced making simple but funny/happy ghost and monster faces.
Once I had an idea of what I wanted, I used my black sharpie to draw on the outlines of the faces, and then came back and used black and white paint to fill in the details.
For the ghost, I used duct tape to stick on strips of white vinyl inside the bottom rim of the can for the streamers. I happen to work at a company that has vinyl scraps in the trash, but a trash bag or ribbons or even a vinyl tablecloth cut into strips would also work. At the top, I punched a small hole with a hammer and nail, and then screwed a cup hook into that hole, using a wine cork on the inside to hold it all together.
And then my attention turned to my Frankenstein can. And I realized I had painted it upside down – the open end was at the top.
Whoops! It sure was easier to hold onto while I painted it that way, but now I had to figure out how to put the streamers and hooks on it.
I decided to use a bottle opener to cut holes in the bottom of that can, and then threaded through strips of black material. This is much easier (and much less likely to result in a need for a tetanus shot) if you thread them from the outside into the holes to the inside. I pulled each strip up to where I could reach it, and then tied a big knot in each which keeps it from falling back through the hole.
For the hanger, I punched holes in the sides and threaded some thin gauge wire through, and then twisted that into a hanging loop at the top.
On both versions, I cut the streamer strips at random heights, and then cut a notch in the bottoms to make them a little more finished.
These were fun to make – my plan is to keep saving cans through the month and keep adding to the collection. I’m thinking a vampire, a pumpkin and maybe a mummy?
